beautypg.com

Conditions for multifeed detection, Index contents, Appendix glossary introduction top – Fujitsu Ricoh Fujitsu fi-7700 Document Scanner User Manual

Page 52

background image

Index

Contents

Chapter 2 How to Load Documents

Appendix

Glossary

Introduction

TOP

52

How to Use the
Operator Panel

Various Ways to
Scan

Daily Care

Troubleshooting

Operational
Settings

Replacing the
Consumables

Scanner
Overview

How to Load
Documents

Conditions for Multifeed Detection

Multifeed is an error where two or more sheets are fed through
the ADF at once. When a different document length is
detected, this detected result is also called a multifeed.
Multifeed detection is performed by either checking the
overlapping of documents, length of the documents, or the
combination of both. The following conditions are required for
an accurate detection.

Detection by Overlapping

Paper weight: 20 to 413 g/m

2

(5.3 to 110 lb)

Do not punch holes within 35 mm (1.38 in.) over the center of the
document. See

"Fig. 1" (page 51)

.

Do not attach other documents within 35 mm (1.38 in.) over the
center of the document. See

"Fig. 1" (page 51)

.

Detection by Length

Load documents of the same length in the ADF paper chute (feeder).

Variance in document lengths: 1% or less

Do not punch holes within 35 mm (1.38 in.) over the center of the
document. See

"Fig. 1" (page 51)

.

Detection by Overlapping and Length

Load documents of the same length in the ADF paper chute (feeder).

Paper weight: 20 to 413 g/m

2

(5.3 to 110 lb)

Variance in document lengths: 1% or less

Do not punch holes within 35 mm (1.38 in.) over the center of the
document. See

"Fig. 1" (page 51)

.

Do not attach other documents within 35 mm (1.38 in.) over the
center of the document. See

"Fig. 1" (page 51)

.

ATTENTION

The above condition applies when the document is set to the center
of the pick roller width.

When you use detection by overlapping, scanning thick documents
such as plastic cards will be falsely detected as multifeed. In that
case, specify one of the following settings and try scanning again.
- Use the Intelligent Multifeed function.
- Disable the multifeed detection setting.
- Use the Manual/Single mode.

HINT

Accuracy of multifeed detection may drop with some documents.
Multifeed cannot be detected for the top 30 mm of a document.

For the shaded area in

"Fig. 1" (page 51)

, you can also specify a

length not to detect multifeeds in the Software Operation Panel.
For details, refer to

"8.6 Settings Related to Multifeed Detection"

(page 199)

.