Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 40)

Index
Contents
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
40
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
This section explains how to load documents in the ADF.
Preparation
1
If you are loading multiple sheets, check the documents.
1 Check if the documents to be loaded are of the same width or
different widths.
Ways to load documents differ depending on whether they are the
same width or not.
If the document width varies, refer to
"Conditions for Mixed Batch
Scanning" (page 53) or " Scanning Documents with Different
Widths" (page 85) .
2 Check the number of sheets.
The number of sheets that can be loaded is as follows:
 A4/Letter size documents or smaller
300 sheets (with paper weight of 80 g/m
2
[20 lb] and thickness
of the document stack under 30 mm)
 Documents larger than A4/Letter size
100 sheets (with paper weight of 80 g/m
2
[20 lb] and thickness
of the document stack under 10 mm)
For details, refer to "Loading Capacity" (page 50) .
2
Fan the documents.
1 Take out a stack of documents, according to the thickness in the
following guidelines:
 A4/Letter size documents or smaller
30 mm or less
 Documents larger than A4/Letter size
10 mm or less
2 Hold both ends of the documents and fan them a few times.
3 Rotate the documents by 90 degrees and fan them in the same
manner.
4 Perform steps 1 to 3 for all documents.
5 Align the edges of the documents.
2.1 Loading Documents in the ADF
HINT
For details about the paper size and quality required for normal
operations, refer to
"2.3 Documents for Scanning" (page 47) .
HINT
For more details about how to fan documents, refer to the Error
Recovery Guide.