beautypg.com

Device errors, Device, Appendix – Fujitsu Ricoh Fujitsu fi-7700 Document Scanner User Manual

Page 131: Glossary introduction index contents top

background image

Appendix

Chapter 7 Troubleshooting

Glossary

Introduction

Index

Contents

TOP

131

How to Load
Documents

How to Use the
Operator Panel

Various Ways to
Scan

Daily Care

Operational
Settings

Replacing the
Consumables

Scanner
Overview

Troubleshooting

Transport Lock, Cover Open, and Print Errors

Error codes beginning with the letter "U" are displayed.

*1: When you open the ADF while the scanner is in standby, only an error

message will appear without an error code.
Also, note that buttons on the operator panel are disabled while the
ADF is open.

*2: When you open the imprinter print section while the scanner is in

standby, only an error message will appear without an error code.
Also, note that buttons on the operator panel are disabled while the
imprinter print section is open.

*3: Displayed when the imprinter is installed.

Device Errors

The following are lists of device errors which require
troubleshooting by a service engineer.

Internal and Optical Errors

Error codes beginning with the letter "E" are displayed.

Error

code

Error messages

Action

U0:10

Transport lock
error
Unlock the
transport lock
switch.

[fi-7700/fi-7700S]
Unlock the transport lock.
For details, refer to the Quick Installation
Sheet.

U4:40
(*1)

ADF open

Close the ADF and reload the
documents.

U5:4A
(*2)
(*3)

Imprinter Cover
Open

Close the print section of the imprinter,
and load the document again.

U6:B4
(*3)

Print cartridge not
installed
Check if the Print
Cartridge is
mounted
correctly.

This error is related to the imprinter.
For details, refer to the fi-760PRB
Imprinter Operator's Guide.

U7:B9
(*3)

Imprinting area
error

Adjust the imprinting start position and
the imprinter strings to fit the imprinting
area in the document.
For details, refer to the fi-760PRB
Imprinter Operator's Guide.

Error

code

Error messages

Action

E0:87

FB carrier error
Unlock the transport
lock switch.

[fi-7700/fi-7700S]
Unlock the transport lock.
For details, refer to the Quick
Installation Sheet.

E1:7E

Optical error (FB)
If the problem persists
after turning the power
back on, please inform
your service provider
of the above error
code.

[fi-7700/fi-7700S]
1 Check whether the transport lock

is unlocked.
For details, refer to the Quick
Installation Sheet.

2 Turn the scanner off then back on.

If the problem persists, write
down the displayed error code
and contact the distributor/dealer
where you purchased this
product.