Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 146)

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
146
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
An error (error code "U0:10", "U4:40" or "U5:4A")
is already displayed in the LCD after power-on.
Did you unlock the transport lock?
[fi-7700/fi-7700S]
No
Turn off the scanner and unlock the transport lock.
For details about how to turn off the scanner, refer to
"1.3 Turning the Power ON/
OFF" (page 23) .
For details about how to unlock the transport lock, refer to the Quick Installation
Sheet.
Yes
Does the problem persist after turning the power off then
back on?
No
The scanner is operating correctly.
Yes
Is error code "U4:40" or "U5:4A" displayed in the LCD
while the LED indicator is flashing?
Yes
Close the ADF and the print section of the imprinter (only when the imprinter is
installed) properly.
For details, refer to
"1.4 Opening/Closing the ADF" (page 24) .
If the indication does not return to the [Ready] screen after you closed the ADF,
check the items in
"7.4 Before You Contact the Scanner Service Provider" (page
156) first, then contact the distributor/dealer where you purchased this product.
No
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 156) first, then contact the distributor/dealer where you
purchased this product.