beautypg.com

Appendix glossary introduction index contents top – Fujitsu Ricoh Fujitsu fi-7700 Document Scanner User Manual

Page 102

background image

Chapter 4 Various Ways to Scan

Appendix

Glossary

Introduction

Index

Contents

TOP

102

How to Load
Documents

Daily Care

Troubleshooting

Operational
Settings

Replacing the
Consumables

Scanner
Overview

Various Ways to
Scan

How to Use the
Operator Panel

Disabling Paper Protection for a Single Scan
After Paper Protection Is Set Off

If you attempt to scan a wrinkled document while paper
protection is on, the scanner may detect it as a paper jam,
which causes paper protection to be set off and forces a scan
to be stopped even though paper is fed normally. In this case,
you can disable paper protection on the operator panel for a
single scan after paper protection is set off.
Note that, in some ambient conditions, you may not be able to
successfully scan documents with the document cover open.

Operational Procedure

1

After paper protection is set off, open the ADF and
remove the document.

After the document is removed, indication on the LCD of the operator
panel changes as follows:

2

If you open the ADF to remove the document, close it.

For details, refer to

"1.4 Opening/Closing the ADF" (page 24)

.

3

Load the documents back in the ADF paper chute
(feeder).

Menu

Scan/Enter

Check

Power

Stop/Clear

LCD

[fi-7600]

[Menu] Button

[Scan/Enter] Button

Menu

Scan/Enter

Check

Powe

Power

Stop/Clear

LCD

[fi-7700/fi-7700S]

[Menu] Button

[Scan/Enter] Button

When paper protection is set off

When a document is

ejected

Paper protection (feeding noise)
Remove and check the document, and
then try again carefully.

Disable paper
protection.
--------------------------------
Enable:Scan/Enter
(Switch:Menu)

Paper protection (feeding accuracy)
Remove and check the document, and
then try again carefully.

When the ADF is open, it might close
accidentally. Be careful not to get your
fingers caught.

Be careful not to get your fingers caught
when closing the ADF.

ATTENTION

Confirm that the ADF is closed properly. Otherwise, the document
may not be fed into the ADF.