Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 33)

Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
33
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
This section explains about the basic flow of performing a
scan.
In order to perform a scan, you need a scanner driver and an
image scanning application that supports the scanner driver.
The following scanner drivers and image scanning
applications are bundled with the scanner:
 Scanner driver
- PaperStream IP (TWAIN)
- PaperStream IP (TWAIN x64)
- PaperStream IP (ISIS) Bundle
 Image scanning application
- PaperStream ClickScan
- PaperStream Capture
Scanning procedures and operations slightly vary depending
on the image scanning application.
For details, refer to the image scanning application manual.
The following describes the normal procedure for scanning.
1
Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page 23) .
2
Load documents in the ADF paper chute (feeder).
Load the documents face-down in the ADF paper chute (feeder).
For details, refer to "Chapter 2 How to Load Documents"
(page 39) .
3
Start an image scanning application.
4
Select a scanner driver.
For some image scanning applications, selection of a scanner driver
may not be needed.
1.10 Basic Flow of Scanning Operation
HINT
For details about the scanner drivers and image scanning applications,
refer to
"1.11 Bundled Software" (page 35) .