Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 71)

How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
71
How to Load
Documents
Scanner
Overview
■
Counting Documents
1
Press the [Power] button on the operator panel.
 The [Ready] screen is displayed on the LCD.
2
Press the [Menu] button.
 The [Settings Menu] screen is displayed on the LCD.
3
Press the [  ] or [  ] button and select [12: Doc Counting
Mode], then press the [Scan/Enter] button to confirm.
 The [Doc Counting Mode (More documents)] screen is displayed on
the LCD.
4
Load a document in the ADF paper chute (feeder), and
press the [Scan/Enter] button.
 The number of sheets that are scanned is counted.
The number of counted sheets is displayed in Count.
2 [Menu] Button
3 [  ]/[  ] Button
[Scan/Enter] Button
4 [Scan/Enter] Button
1 [Power] Button
Menu
Scan/Enter
Check
Powe Power
Stop/Clear
Menu
Scan/Enter
Check
Power
Stop/Clear
[fi-7600]
[fi-7700/fi-7700S]
ATTENTION
Documents may not be counted correctly if a multifeed occurs
during scanning.
HINT
 To reset Count, press the [Stop/Clear] button while the [Doc
Counting Mode (More documents)] screen is displayed.
 To end Doc Counting Mode, press the [Stop/Clear] button for
three seconds or longer while the [Doc Counting Mode (More
documents)] screen is displayed.