Fujitsu Ricoh Fujitsu fi-7700 Document Scanner - Manual (Page 206)

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
206
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Waiting Time for the Scanner to Enter Power
Saving Mode [Power saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 160) .
2
From the listing on the left, select [Device Setting].
HINT
 When [Continuous Feed Mode] is enabled, the scanner will wait
for the next document to be loaded until the specified time
elapses even if you start scanning with no document in the ADF
paper chute (feeder).
 When the feed mode switch is set to Manual/Single mode, even
if the Enable option is selected for [Continuous Feed Mode] in
[Manual Feeding], the scanner operates in Manual/Single
mode.
 This setting can also be configured with the operator panel.