HP UX B6941-90001 - Manual (Page 99)

Chapter 2 99
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
showrev -p
Installation Tips for Windows NT Systems
This section explains how to install the ITO agent package on Windows
NT systems. There are four installation procedures that you can use
depending on the network configuration as described in Table 2-4 on
page 99:
NOTE In this manual, a Windows NT installation server is a primary or
backup domain controller with the ITO agent package installed.
Table 2-4 NT-Agent Installation Options
Use the...
described
on...
to install or upgrade the NT agent
package on...
ftp installation page 103 • a primary or backup domain
controller
• a primary or backup domain
controller that does not give
administrative rights
a
to the HP
ITO account on an installation
server in another domain
• a stand-alone system
standard
installation page 106 • a system that has an installation
server in its domain
• a system in a domain that gives
administrative rights
a
to the HP
ITO account on an installation
server in another domain