HP UX B6941-90001 - Manual (Page 37)

Chapter 1 37
Prerequisites for Installing ITO Agent Software
Managed Node Requirements
❏ Operating System. For the supported OS versions, see Table 1-1 on
page 31.
❏ If only the Multi-User operating environment is installed, then the
networking package, WIN-TCP, must also be installed.
❏ NCS Version 1.5.1 (package NckNidl) or StarPRO DCE Executive
from NCR UNIX SVR4.
If neither NCS nor StarPRO DCE are found on the managed node,
ITO installs
llbd and lb_admin during the ITO agent software
installation.
❏ The MIB monitoring functionality of ITO requires SNMP-based,
MIB-I (RFC 1156) or MIB-II (RFC 1158) compliant agent software.
Software Requirements for Novell NetWare Managed
Nodes
The following software must be installed on Novell NetWare managed
node:
❏ Operating System. For the supported OS versions, see Table 1-1 on
page 31.
❏ TCP/IP services configured, running and automatically started
❏ Network FRAMING types must be configured (Ethernet II frame type
is required)
❏ CLIB.NLM version 4.10 or higher
❏ Novell TIRPC (If this product is missing ITO copies the required files
during the installation process.)
❏ SNMP daemon configured, running and automatically started
❏ XCONSOLE configured and running: remote console access (via
telnet) must be allowed
XCONSOLE.NLM must be installed and configured on each server.
XCONSOLE is part of Novell products like Flex-IP or NetWare/IP.
❏ Novell NMA 2.1 installed and configured
Novell NMA 2.1 is a NetWare add-on product and can be purchased
from Novell. Note that almost all ITO NetWare agent
instrumentation is based on NMA. NetWare servers which do not run
NMA can, therefore, only be managed in a very limited way by ITO.