HP UX B6941-90001 - Manual (Page 83)

Chapter 2 83
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
reboot. If the string is found you are notified that in order to
run the ITO agent for the NetWare server, TCP/IP must be
invoked.
If there is no such string the NetWare server may use the
configurator,
INETCFG.NLM , to set network parameters.
Inspect the AUTOEXEC.NCF file for inclusion of the string
INITSYS on a separate line to determine if this method is used.
If this is the case the file SYS:ETC/NETINFO.CFG is checked
for the string TCPIP. If the string is found you are warned that
in order to run ITO server, TCP/IP should be invoked and it is
suggested that you also run
INETCFG.NLM .
If the presence of TCPIP cannot be determined the procedure
exits. The installation procedure does not try to invoke TCPIP
because of its complexity and the problems that this may
cause.
• Checks for TIRPC
The ITO management server requires the TIRPC module. If
the installation process does not find the module and it is not
located in
SYS:SYSTEM , a warning is displayed. You can safely
ignore this warning message because the TIRPC module was
already copied when unzipping the package.
• Checks for XCONSOLE
The active modules list and the AUTOEXEC.NCF and/or
NETINFO.CFG are scanned for XCONSOLE . XCONSOLE requires
REMOTE.NLM . If the strings REMOTE and/or XCONSOLE do not
exist in either of the two configuration files, the installation
procedure updates
AUTOEXEC.NCF by inserting the
appropriate command(s) at the end of the file:
either: load remote
or: load xconsole
or both.
If the string REMOTE is not present, the installation procedure
prompts you for the remote console password.
On NetWare SFT III servers, the installation procedure cannot
check whether
REMOTE.NLM is running. If it isn’t, you are not
prompted for the remote console password. XCONSOLE.NLM is