HP UX B6941-90001 - Manual (Page 30)

30 Chapter 1
Prerequisites for Installing ITO Agent Software
Managed Node Requirements
❏ The ITO agent must be installed on an HPFS partition: FAT
partitions are not supported for ITO Agent installation and operation.
❏ Additional swap space: none
❏ Additional RAM: 4MB
UNIX Hardware Requirements
The UNIX systems you select as managed nodes must meet the following
hardware requirements:
❏ 10 MB disk space free
(About 20 MB is required during software installation.)
❏ Additional swap space: none
❏ Additional RAM: none
NOTE Only PA-RISC version 1.1 is supported on HP-UX 10.x managed nodes.
Windows NT Hardware Requirements
The Windows NT systems you select as managed nodes must meet the
following minimum hardware requirements:
❏ Windows NT 4.0 Workstation or Server
• Windows NT 4.0 Server: 16 MB Memory
• Windows NT 4.0 Workstation: 12 MB Memory
❏ 10 MB disk space on local NTFS disk
❏ During installation, an additional 10 MB of disk space is required on
the local C: drive
Software Requirements
This section lists the specific versions of the various agent operating
systems that are supported by ITO and also provides information
concerning how the software requirements for agents vary according to
the specific operating system. In addition, this section explains what
requirements exist for communication software (DCE and NCS) for each
agent platform.