HP UX B6941-90001 - Manual (Page 108)

108 Chapter 2
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
• Installation Server : enter the name of a Windows NT
domain controller that has been set up as an installation server
(and is in the same domain, or has administrative rights for the
HP ITO account in this domain). This example uses the system
ntserver.com .
• If Service Pack 1 or 2 is installed on your Windows NT version
3.51 or 4.0 managed node, change the communication type from
DCE RPC (UDP) to DCE RPC (TCP) .
6. Click [Close] to dismiss the Advanced Options window, then
[OK] in the Add Node window.
7. Add the new node to a node group so that it can be managed by an
ITO operator:
a. Open the ITO Node Group Bank window and double-click the
node group to which you want to add the node.
Add a new node group if you do not want to use one of the ITO
default node groups. Remember to assign any new node groups to
an operator.
b. Drag the node from the ITO Node Bank window and drop it into
the submap of the node group.
8. You can monitor the rest of the installation by looking at messages
received in the message browser. If you added a new group, configure
the message browser to receive messages from this new group. If the
message browser is open, it will prompt you for a restart when you
finish the step above. If it is not open, add the new node group and
open the message browser now.
9. Click the new icon to highlight it, then choose
Actions:Agents->Install/ Update SW & Config… to display
the Install/Update ITO Software and Configuration
window.
10. Under Target Nodes , select [Nodes in list requiring
update] , then click [Get Map Selection] , the node name will
appear in the window.
11. Under components, select [Agent Software] , then click [OK] .
The installation will begin. A new shell will open and start the
installation script. When prompted for the HP_ITO password you can
either specify a password, or simply press
Enter and ITO will create a
password for you.