HP UX B6941-90001 - Manual (Page 170)

170 Chapter 4
Software Maintenance on Managed Nodes
Installing or Updating ITO Software Automatically
NOTE Manual activation of the ITO agent software on NFS Cluster Client
Nodes is only supported for HP-UX 10.x/11.x, AIX, Solaris, NCR and
SINIX managed node with ITO version A.05.00 and higher. In addition,
only homogeneous NFS Clusters are supported and the cluster server
and cluster client systems must have the same OS.
To manually install the ITO agent on an NFS Cluster-Client managed
node:
1. Install the ITO agent on NFS Cluster Server system (see Install the
Agent on the Managed Node chapter for details).
NOTE This action should be executed only once to install the ITO agents on the
NFS Cluster.
If the ITO agent software is to be re-installed, make sure that the ITO
agents have been stopped on all NFS cluster nodes before starting the
re-installation.
2. Execute the following command on the NFS Cluster Server system
opcactivate -mode cluster_server \
3. Execute the following command on the NFS Cluster Client system:
opcactivate -mode cluster_client
4. After the node is connected to the network execute the following two
commands on the management server:
opcsw -installed
opchbp -start
This updates the database and starts heartbeat polling for the node.
The templates, monitors, commands, and actions must still be
installed using the ITO administrator GUI.
Changing the Communication Type
For the managed node platforms that support both NCS RPC and DCE
RPC, you can choose between these communication types.