HP UX B6941-90001 - Manual (Page 305)

Chapter 6 305
Installing/Updating the ITO Configuration on the Managed Nodes
Configuration Installation/Update on Managed Nodes
6. ITO compresses the monitor|actions|cmds binaries. Do not put a
file into the following directory, if the same file name already exists
with a .Z extension:
/var/opt/OV/share/databases/OpC/mgd_node/customer/\
< arch >/{monitor|actions|cmds}
Tips for Script Program Distribution to UNIX
Managed Nodes
❏ For mixed clusters, the monitor|actions|cmds scripts and
programs need only be installed once for each architecture type, by
selecting one appropriate cluster node.
❏ The file names of the monitor|actions|cmds binaries must not be
longer than 14 characters (including the .Z extension if compressed).
This limitation is set to ensure smooth processing on nodes running
with short file names.
Tips for Script Program Distribution to HP-UX
Managed Nodes
Customer-written programs for HP 9000 series 700 computers (Technical
Workstations) should be compiled using the -DA1.1 option (HP-PA
compatibility mode). This is because these programs must also run on
HP 9000 series 800 computers (Enterprise Servers). (ITO does not
distinguish between these two architectures.) If this is not possible, the
following symbolic link must be replaced by an ordinary s800/hp-ux
directory tree for HP-UX 10.x managed nodes:
/var/opt/OV/share/databases/OpC/mgd_node/customer/hp\
/s800/hp-ux -> ../../s700/hp-ux
Distributing the ITO Agent Configuration to
the Managed Nodes
After customizing the configuration and assigning templates to managed
nodes, distribute the managed node configuration by selecting both the
appropriate managed nodes, and the Templates component in the
Install/Update ITO Software and Configuration window. If no
configuration change has been made since the last configuration
distribution, no new distribution is triggered unless you select the
Force
Update option.