HP UX B6941-90001 User Manual

Page 32

Chapter 1

Prerequisites for Installing ITO Agent Software

Managed Node Requirements

a. DCE can be purchased at additional cost for some of these agent platforms, either

from the platform vendor, or from a third-party supplier.

b. HP 9000/700 workstations are now referred to as HP 9000 Technical

Workstations.

c. HP 9000/800 servers are now referred to as HP 9000 Enterprise Servers.
d. ITO uses the same binaries as for HP 9000 Technical Workstations.
e. NCR hardware types: 4700, 5100, and 5150 are supported only if the installed ver-

sion of the standard NCR UNIX operating system is supported by ITO and any
additional software which is installed does not change the IP address of the NCR
node under any circumstances (takeover, etc).

f. Transport Independent Remote Procedure Call
g. ITO does not yet support special editions of the Windows NT Server operating

system; for example, Windows NT Server Enterprise Edition or Windows NT
Server Terminal Server Edition; nor does it support any software products
extending these editions; for example, WinFrame or MetaFrame from Citrix
Systems, Inc.. Contact your local HP Sales Representative for the latest
information about support for these products.

h. ITO supports the remote protocol calls (RPCs) but not the security features.

Additional agent platforms may also be supported by HP partners, or
directly by HP, either currently or in the near future. For a current list of
supported agent platforms, contact your HP representative.

OS/2 Warp

Intel 486 or higher

3.0, 4.0

DCE

SCO OpenServer

Intel 486 or higher

3.2 (v4.0, v4.2,
v5.0.0, v5.0.1, v5.0.2,
v5.0.3, v5.0.4, v5.0.5)

NCS

SCO UnixWare

Intel 486 or higher

2.1

DCE

SINIX/Reliant

Siemens-Nixdorf

5.43, 5.44

NCS/DCE

Solaris

Sun SPARCstation

2.5, 2.51, 2.6, 7

NCS

Windows NT

Intel 486 or higher

3.51, 4.0 (NT server
and workstation)

DCE

DEC Alpha

Operating System

Platform

Supported OS

Versions

Supported

Communication

Type