HP UX B6941-90001 - Manual (Page 73)

Chapter 2 73
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
where for example, is Maestro's
mstream.
If there is no entry for ITO in SYSSTART.PUB.SYS , the automatic
software installation will insert an entry for ITO in
SYSSTART.PUB.SYS where the major parts look like this:
comment ... OperationsCenter
OPCSTRTJ.BIN.OVOPC
❏ The executable library, SNMPXL.NET.SYS , must be available, and
ITO must have execution rights; if not, the ITO Monitoring Agent will
not operate.
❏ The TIMEZONE variable must be set to correct differences between
the different time resources used by ITO’s C-routines and MPE’s
intrinsics and commands; if not, messages and error and trace logfiles
receive the wrong creation time stamp. This can cause problems when
working with multiple management servers.
Insert the following call at a global location, for example the logon
UDC or
SYSSTART.PUB.SYS :
call: setvar TZ,”TIMEZONE”
Required MPE/iX Patches
❏ Patch MPEKXE5A must be installed on all MPE/iX 5.5 systems. This
patch adds routines to the system SL.PUB.SYS that the console
interceptor requires to operate. This patch may be incorporated into
future MPE Power Patch releases.
❏ Patch MPEKXE5B must be installed on all MPE/iX 6.0 systems. This
patch adds routines to the system SL.PUB.SYS that the console
interceptor requires to operate. This patch may be incorporated into
future MPE Power Patch releases.
❏ Patch ITOED07A must be installed on all MPE/iX 6.0 systems. This
patch provides routines to the XL.PUB.SYS to allow the ITO agent to
call various NCS routines. This patch may become unnecessary for
future MPE agent versions.