HP UX B6941-90001 - Manual (Page 102)

102 Chapter 2
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
• Schedule services must not be disabled.
• SNMP services must be running for ITO to automatically identify
the node as an NT system. This is helpful, but not absolutely
necessary for a successful installation.
❏ Requirements for a Windows NT Installation Server
• All Windows NT node requirements as listed above.
• Additional four MB of space must be free on an NTFS-formatted
local disk that is available to the node.
• Ten MB free disk space must be temporarily available on the drive
that contains the ftp directory during installation.
• An installation server must be a primary domain controller or a
backup domain controller.
• ftp services must be running on the primary or backup domain
controller if the agent package is being installed from the ITO
management server (this will always be true for the first
installation).
• The ftp service must have read/write permission for drive that
contains the ftp home directory.
❏ Requirements for the ITO Management Server
• The ITO management server must be installed with the client
software bundle OVOPC-NT-CLT. You can verify that the bundle
has been installed with the command:
swlist -l fileset OVOPC-CLT.OVOPC-NT-CLT
• If your installation includes 35 or less NT managed nodes, use the
setting for the kernel parameter maxfiles given in the HP
OpenView IT/Operations Installation Guide for the Management
Server. If your installation includes more than 35 NT managed
nodes, increase the setting of maxfiles by:
3*Number_of_additional_NT_nodes + 15