General installation notes for netware nodes – HP UX B6941-90001 User Manual
Page 85
Chapter 2
85
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
• Updates system configuration files
The Installation procedure updates the
OPCINFO
file and
writes the ITO start command (
OPCAGT.NCF
) to the
AUTOEXEC.NCF
. On NetWare SFT III systems,
OPCAGT.NCF
is
added to
SYS:SYSTEM/MSAUTO.NCF
.
The
SYS:/ETC/HOSTS
file is updated with the IP address of
the ITO management server if you agreed to add the ITO
management server to the
SYS:/ETC/HOSTS
file.
The internet name and IP address of the target NetWare
server that is currently processed are also required and must
be entered now. Both are added to the
SYS:/ETC/HOSTS
file. If
you are installing a NetWare SFT III managed node, enter the
name and IP address of the MS Engine.
• Creates ITO Operator and Group
The NetWare group OPCGRP is created, and the NetWare user
OPC_OP is added to the OPCGRP group; OPC_OP has the
same security level as the user ADMIN. All these actions are
performed in bindery or NDS mode.
CAUTION
Do not forget to manually change the password for the user OPC_OP.
j. When all selected servers have been processed a special
.NLM
is
invoked at the depot server to perform a shutdown at the time you
previously scheduled. The shutdown is only performed if no files
are opened on the NetWare server. There is no forced shutdown.
6. Inform the management server that the agent software has been
successfully installed on the new ITO managed nodes. Enter:
/opt/OV/bin/OpC/opcsw -installed <
node_name>
7. Assign your templates to the NetWare managed nodes and distribute
the templates, actions, monitors, and commands. See the HP ITO
Administrator’s Guide to Online Information for more information
about assigning and distributing templates.
General Installation Notes for NetWare Nodes
❏ Each step of the installation is recorded in the logfile
SYS:DEPOINST.ITO/ITOINST
. If you encounter problems during the
installation, check this logfile for warnings and errors, and retry the
installation if necessary.