HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 76)

76 First Steps with the iTNC 530
1
.7 Running the first pr
ogr
am
1.7 Running the first program
Selecting the correct operating mode
You can run programs either in the Single Block or the Full Sequence
mode:
 Press the operating mode key: The TNC goes into the
Program Run, Single Block
mode and the TNC
executes the program block by block. You have to
confirm each block with the NC start key
 Press the Program Run, Full Sequence operating
mode key: The TNC switches to that mode and runs
the program after NC start up to a program
interruption or to the end of the program
Further information on this topic
 Operating modes of the TNC: See "Operating modes", page 82
 Running programs: See "Program Run", page 649
Choosing the program you want to run
 Press the PGM MGT key: The TNC opens the file
manager
 Press the LAST FILES soft key: The TNC opens a pop-
up window with the most recently selected files
 If desired, use the arrow keys to select the program
that you want to run. Load with the ENT key
Further information on this topic
 File management: See "Working with the file manager", page 124
Start the program
 Press the NC start key: The TNC runs the active
program
Further information on this topic
 Running programs: See "Program Run", page 649