HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 415)

HEIDENHAIN iTNC 530 415
1
1
.2 Dynamic Collision Monit
o
ri
ng (sof
tw
ar
e option)
Collision monitoring in the Test Run mode of
operation
Application
This feature enables you to test for collisions before actual machining.
Requirements
Conducting a collision test
 Select the Test Run operating mode
 Select the program that you want to check for collision
 Select the screen layout PROGRAM+KINEMATICS or
KINEMATICS
 Shift the soft-key row twice
 Set the collision testing to ON
 Shift the soft-key row back twice
 Start the test run
The graphic simulation testing must be enabled by your
machine tool builder in order to run.
You specify the datum for the collision test in the
“workpiece blank in working space” function (see
"Showing the workpiece blank in the working space" on
page 684)!