HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 654)

654 Test Run and Program Run
16.4 Pr
ogr
am Run
Resuming program run after an interruption
If you interrupt a program run during execution of a subprogram or
program section repeat, use the RESTORE POS AT N function to
return to the position at which the program run was interrupted.
When a program run is interrupted, the TNC stores:
 The data of the last defined tool
 Active coordinate transformations (e.g. datum shift, rotation,
mirroring)
 The coordinates of the circle center that was last defined
The TNC uses the stored data for returning the tool to the contour after
manual machine axis positioning during an interruption (RESTORE
POSITION soft key).
Resuming program run with the START button
You can resume program run by pressing the machine START button
if the program was interrupted in one of the following ways:
 Machine STOP button pressed
 Programmed interruption
Resuming program run after an error
 Remove the cause of the error
 Clear the error message from the screen: Press the CE key
 Restart the program, or resume program run where it was
interrupted
After a control software crash,
 Press and hold the END key for two seconds. This induces a TNC
system restart
 Remove the cause of the error
 Restart
If you cannot correct the error, write down the error message and
contact your service agency.
If a program run is interrupted during a fixed cycle, the
program must be resumed from the beginning of the
cycle. This means that some machining operations will be
repeated.
Note that the stored data remain active until they are reset
(e.g. if you select a new program).