HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 646)

646 Test Run and Program Run
16.3 T
est Run
Executing a test run up to a certain block
With the STOP AT N function the TNC does a test run only up to the
block with block number N.
 Go to the beginning of program in the Test Run mode of operation.
 Select "Test Run up to a specific block": Press the STOP AT N soft
key
 Stop at N: Enter the block number at which you wish
the test to stop
 Program: Enter the name of the program that contains
the block with the selected block number. The TNC
displays the name of the selected program. If the test
run is to be interrupted in a program that was called
with PGM CALL, you must enter this name
 Start-up at: P: If you want to start in a point table,
enter here the line number at which you want to start
 Table (PNT):
If you want to start in a point table, enter
here the name of the point table in which you want to
start
 Repetitions: If N is located in a program section
repeat, enter the number of repeats that you want to
run
 To test a program section, press the START soft key.
The TNC will test the program up to the entered block