beautypg.com

2 mo ving the mac h ine ax es – HEIDENHAIN iTNC 530 (60642x-04) User Manual

Page 578

background image

578

Manual Operation and Setup

14.2 Mo

ving the mac

h

ine ax

es

Inputting spindle speed S

Press the handwheel soft key F3 (MSF)

Press the handwheel soft key F2 (S)

Select the desired speed by pressing the F1 or F2 key. If you press

and hold the respective key, each time it reaches a decimal value 0

the TNC increases the counting increment by a factor of 10. If in

addition you press the CTRL key, the counting increment increases

to 1000

Activate the new speed S with the NC start key.

Entering the feed rate F

Press the handwheel soft key F3 (MSF)

Press the handwheel soft key F3 (F)

Select the desired feed rate by pressing the F1 or F2 key. If you

press and hold the respective key, each time it reaches a decimal

value 0 the TNC increases the counting increment by a factor of 10.

If in addition you press the CTRL key, the counting increment

increases to 1000

Confirm the new feed rate F with the handwheel soft key F3 (OK)

Set datum

Press the handwheel soft key F3 (MSF)

Press the handwheel soft key F4 (PRS)

If required, select the axis in which the datum is to be set

Reset the axis with the handwheel soft key F3 (OK) or with F1 and

F2 set the desired value and then confirm with F3 (OK). By also

pressing the CTRL key, you can increase the counting increment to

10

Changing operating modes
With the handwheel soft key F4 (OPM) you can use the handwheel to

switch the mode of operation, provided that the current status of the

control allows a mode change.

Press the handwheel soft key F4 (OPM)

Select the desired operating mode by handwheel soft key

MAN: Manual operation

MDI: Positioning with manual input

SGL: Program run, single block

RUN: Program run, full sequence