New functions in version 60642x-03 – HEIDENHAIN iTNC 530 (60642x-04) User Manual
Page 18
New functions in v
e
rsion 60642x
-03
18
New functions in version 60642x-03
New software option Active Chatter Control (ACC) (see "Active
Chatter Control (ACC; software option)" on page 457)
Improvement of Dynamic Collision Monitoring (DCM):
For the NC syntax SEL FIXTURE, the software now supports a
selection window with file preview for selecting saved fixtures
(see "Loading fixtures under program control" on page 426)
The nesting depth for program calls has been increased from 10 to
30 (see "Nesting depth" on page 306)
When using the second Ethernet interface for a machine network,
you can now also configure a DHCP server to provide the machines
with dynamic IP addresses (see "General network settings" page
674 ff)
Machine parameter 7268.x can now be used to arrange or hide
columns in the datum table (see "List of general user parameters"
The SEQ switch of the PLANE function can now also be assigned a
Q parameter (see "Selection of alternate tilting possibilities: SEQ +/–
(entry optional)" on page 509)
Improvements to the NC editor:
Saving a program (see "Deliberately saving changes" on page 115)
Saving a program under another name (see "Saving a program to
Canceling changes (see "Undoing changes" on page 116)
Improvements to the DXF converter:(see "Processing DXF files
(software option)" page 276 ff)
Improvements to the status bar
The DXF converter saves various pieces of information when it is
exited and restores them when it is recalled
The desired file format can now be selected when saving
contours and points
Machining positions can now also be saved to programs in
conversational format
DXF converter now in new look and feel if the DXF file is directly
opened via the file management