HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 611)

HEIDENHAIN iTNC 530 611
14.9 W
or
k
piece pr
eset
ting with a t
o
uc
h pr
obe
Corner as preset—using points that were
already probed for a basic rotation
 Select the touch probe function: Press the PROBING
P soft key
 Touch points of basic rotation ?
: Press ENT to
transfer the touch point coordinates
 Position the touch probe at a position near the first
touch point of the side that was not probed for basic
rotation
 Select the probe direction by soft key
 Start the probing procedure: Press the NC Start button
 Position the touch probe near the second touch point
on the same workpiece edge
 Start the probing procedure: Press the NC Start button
 Datum: Enter both coordinates of the preset in the
menu window, confirm with the SET DATUM soft
key, or write the values to a table (see "Writing the
measured values from touch probe cycles to datum
tables", page 598, or see "Writing the measured
values from touch probe cycles in the preset table",
page 599, or see "Storing measured values in the
pallet preset table", page 600)
 To terminate the probe function, press the END key
Corner as preset—without using points that
were already probed for a basic rotation
 Select the touch probe function: Press the PROBING P soft key
 Touch points of basic rotation? : Press NO ENT to ignore the
previous touch points. (The dialog question only appears if a basic
rotation was made previously)
 Probe both workpiece edges twice
 Datum : Enter the coordinates of the preset and confirm your entry
with the SET DATUM soft key, or write the values to a table (see
"Writing the measured values from touch probe cycles to datum
tables", page 598, or see "Writing the measured values from touch
probe cycles in the preset table", page 599, or see "Storing
measured values in the pallet preset table", page 600)
 To terminate the probe function, press the END key
P
X=?
Y=?
X
Y
P
X
Y