beautypg.com

14 manual operation and setup – HEIDENHAIN iTNC 530 (60642x-04) User Manual

Page 48

background image

48

14.1 Switch-on, switch-off ..... 564

Switch-on ..... 564
Switch-off ..... 567

14.2 Moving the machine axes ..... 568

Note ..... 568
Moving the axis using the machine axis direction buttons ..... 568
Incremental jog positioning ..... 569
Traversing with electronic handwheels ..... 570

14.3 Spindle speed S, feed rate F and miscellaneous functions M ..... 580

Application ..... 580
Entering values ..... 580
Changing the spindle speed and feed rate ..... 581

14.4 Functional safety FS (option) ..... 582

Miscellaneous ..... 582
Explanation of terms ..... 583
Checking the axis positions ..... 584
Overview of permitted feed rates and speeds ..... 585
Activating feed-rate limitation ..... 586
Additional status displays ..... 586

14.5 Workpiece presetting without a touch probe ..... 587

Note ..... 587
Preparation ..... 587
Workpiece presetting with axis keys ..... 588
Management of presets with the preset table ..... 589

14.6 Using touch-probes ..... 596

Overview ..... 596
Selecting touch probe cycles ..... 597
Recording measured values from the touch-probe cycles ..... 597
Writing the measured values from touch probe cycles to datum tables ..... 598
Writing the measured values from touch probe cycles in the preset table ..... 599
Storing measured values in the pallet preset table ..... 600

14.7 Calibrating touch probes ..... 601

Introduction ..... 601
Calibrating the effective length ..... 601
Calibrating the effective radius and compensating center offset ..... 602
Displaying calibration values ..... 603
Managing more than one block of calibration data ..... 603

14.8 Compensating workpiece misalignment with a 3-D touch probe ..... 604

Introduction ..... 604
Basic rotation using 2 points: ..... 606
Determining basic rotation using 2 holes/studs: ..... 608
Workpiece alignment using 2 points ..... 609

14 Manual Operation and Setup ..... 563