Inserting a unit, 12 smar twizar d – HEIDENHAIN iTNC 530 (60642x-04) User Manual

Page 468

468

Programming: Special Functions

.12 smar

tWizar

Inserting a UNIT



In your conversational program you select the NC block after which

you wish to insert a UNIT



Press the special functions key



Select smartWizard: The TNC displays a soft-key row

showing the available UNIT groups



Using the GOTO key you display a list of all the

available UNITs or select the desired machining UNIT

via the soft-key structure: The TNC displays the form

for the selected UNIT in the right part of the screen

and in the left part you continue to see the

conversational program



Enter all the necessary UNIT parameters, quit the

form with the END key: The TNC inserts all the

conversational program blocks belonging to the

selected UNIT

An overview of all the UNITs available can be found in the

smarT.NC pilot. The pilot also describes the fundamentals

of working with UNITs and how to navigate in the forms.

Note that the first UNIT in your conversational program

must always be the program header UNIT 700. All UNITs

use data from UNIT 700 as preset default values. If there

are no default values available, the TNC will display an

error message.
The UNIT numbers are based on the cycle number with

which the TNC executes the machining in each case.