HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 595)

HEIDENHAIN iTNC 530 595
14.5 W
o
rk
piece pr
eset
ting without a t
o
uc
h pr
obe
Activating a preset from the preset table in the Manual Operation
mode
Select the Manual Operation mode
Display the preset table
Select the preset number that you want to activate, or
With the GOTO key, select the preset number that
you want to activate. Confirm with the ENT key.
Activate the preset
Confirm activation of the preset. The TNC sets the
display and—if defined—the basic rotation
Exit the preset table
Activating a preset from the preset table in an NC program
To activate presets from the preset table during program run, use
Cycle 247. In Cycle 247 you only define the number of the preset that
you want to activate (see User's Manual for Cycles, Cycle 247 SET
DATUM).
Danger of collision!
When activating a preset from the preset table, the TNC
resets the active datum shift.
However, a coordinate transformation that was
programmed in Cycle 19 Tilted Working Plane, or through
the PLANE function, remains active.
If you activate a preset that does not contain values in all
coordinates, the last effective preset remains active in
these axes.