HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 226)

226 Programming: Programming Contours
6.2 F
undamentals of path functions
Creating the program blocks with the path function keys
The gray path function keys initiate the plain-language dialog. The TNC
asks you successively for all the necessary information and inserts the
program block into the part program.
Example—programming a straight line:
Initiate the programming dialog, e.g. for a straight line
Enter the coordinates of the straight-line end point,
e.g. –20 in X
Enter the coordinates of the straight-line end point,
e.g. 30 in Y, and confirm with the ENT key.
Select the radius compensation (here, press the R0
soft key—the tool moves without compensation)
Enter the feed rate (here, 100 mm/min), and confirm
your entry with ENT. When programming in inches,
an entry of 100 equals a feed rate of 10 inches per
minute
Move at rapid traverse: Press the F MAX soft key, or
Traverse with the feed rate defined in the TOOL CALL
block: Press the F AUTO soft key
Enter a miscellaneous function (here, M3), and
terminate the dialog with ENT
The part program now contains the following line:
COORDINATES?
COORDINATES?
RADIUS COMP.: RL/RR/NO COMP.?
FEED RATE F=? / F MAX = ENT
MISCELLANEOUS FUNCTION M?
L X-20 Y+30 R0 FMAX M3
100
3