HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 593)

HEIDENHAIN iTNC 530 593
14.5 W
o
rk
piece pr
eset
ting without a t
o
uc
h pr
obe
Function Soft key
Directly transfer the actual position of the tool
(the measuring dial) as the new preset: This
function only saves the preset in the axis which
is currently highlighted
Assign any value to the actual position of the tool
(the measuring dial): This function only saves the
preset in the axis which is currently highlighted.
Enter the desired value in the pop-up window
Incrementally shift a preset already stored in the
table: This function only saves the preset in the
axis which is currently highlighted. Enter the
desired corrective value with the correct sign in
the pop-up window. If inch display is active: Enter
the value in inches, and the TNC will internally
convert the entered values to mm
Directly enter the new preset without calculation
of the kinematics (axis-specific). Only use this
function if your machine has a rotary table, and
you want to set the preset to the center of the
rotary table by entering 0. This function only
saves the preset in the axis which is currently
highlighted. Enter the desired value in the pop-up
window. If inch display is active: Enter the value
in inches, and the TNC will internally convert the
entered values to mm
Write the currently active preset to a selectable
line in the table: This function saves the preset in
all axes, and then activates the appropriate row in
the table automatically. If inch display is active:
Enter the value in inches, and the TNC will
internally convert the entered values to mm