HEIDENHAIN iTNC 530 (60642x-04) - Manual (Page 596)

596 Manual Operation and Setup
14.6 Using t
o
uc
h-pr
obes
14.6 Using touch-probes
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Please note that HEIDENHAIN grants a warranty for the
function of the touch probe cycles only if HEIDENHAIN
touch probes are used!
Function Soft key Page
Calibrating the effective length Page 601
Calibrating the effective radius Page 602
Measuring a basic rotation using a line Page 606
Setting the datum in any axis Page 610
Setting a corner as preset Page 611
Set a circle center as preset Page 612
Setting the centerline as preset Page 613
Measuring a basic rotation using two
holes/cylindrical studs
Page 614
Setting a preset using four
holes/cylindrical studs
Page 614
Setting a circle center using three
holes/cylindrical studs
Page 614