Enterasys Networks CSX6000 - Manual (Page 83)

H
ARDWARE
I
NSTALLATION
O VERVIEW
This chapter provides a description of the hardware installation process. It includes:
• pre-installation requirements
• selecting slots for adapters
• setting switches
• inserting adapters into backplane
• connecting inter-board cables
Your distributor may have already completed this adapter installation. If not, follow this chapter’s
specific instructions.
P
RE
-I
NSTALLATION
R
EQUIREMENTS
Before you begin the installation process, be sure to:
• Choose a suitable setup location
Make sure the location is dry, ventilated, dust free, static free, and free from corrosive
chemicals
• Verify system power requirements
If applicable, make sure the line voltage select switch is set for the AC input power source
you are going to use. The appropriate standard power cord is supplied with the system.
CAUTION:
When changing the line voltage select switch, make sure the AC power cord is unplugged.
• Verify cabling requirements
The cabling included with your shipment will depend on the country in which your system
will operate. If additional cabling is needed other than what was shipped, contact your
distributor.
Only qualified personnel should install adapters into the
CyberSWITCH.
!
CAUTION
Any time you remove the system module cover, unplug the power
cord. Failure to do so may result in personal injury or equipment
damage.
The CyberSWITCH is sensitive to static discharges. Use a
grounding strap and observe all static precautions during this
procedure. Failure to do so could result in damage to the
CyberSWITCH.