Enterasys Networks CSX6000 - Manual (Page 550)

USER’S GUIDE
550 CyberSWITCH
Out - DL CFG Slot= Port= Ces=
The system is initializing the indicated data link.
Out - DSL CFG Slot= Port=
The system is initializing the indicated line.
Out - init data link
The system is sending a message to the network to initialize a data link on an ISDN line. The
are used to report line details.
Out - PROCEEDING Call Id= Slot= Port= Chans=
Ces= ConnId=
The system is sending a connection to the network. This is sent in response to receiving a call
indication. The are included for your Distributor or Cabletron Customer Support.
Recall dial tone on
Informational call trace message.
Received charge amount -
The system has received an advice of charge from the network for the call just disconnected. The
charge for this call is indicated in the charge amount parameter.
Received unknown abnormal report value Slot= Port= Ces=suffix>
Informational call trace message.
Received unknown progress value
Informational call trace message.
Received unknown signal value
Informational call trace message.
Ringback tone on
Informational call trace message.
Status report progress value received
Informational call trace message.
Stutter tone on
Informational call trace message.
Tones off
Informational call trace message.
Unspecified cause
Informational call trace message. This message is used to indicate additional details on the value> received in the “call progress” information message.Refer to the Cause Codes Table for more
information.
Unspecified tone
Informational call trace message. It is used to indicate additional details on the
received in the “call progress” information message. The is displayed as one of the
following: dial, ring back, answer, call waiting, off hook warning, custom, recall dial, stutter dial,
or expensive routing.