Enterasys Networks CSX6000 - Manual (Page 611)

Central Site Remote Access Switch 611
S YSTEM C OMMANDS
Packet Capture Commands
Banyan Vines Packet Detail Screen (Bridged Packet)
IP Datagram Detail Screen (Routed Datagram)
While the “pkt display” is displayed on your monitor, you can display the following help
screen by entering “?”:
The time menu that is displayed when “t” is entered will enable you to toggle the time
increment to be in either Sec (seconds), mSec (milliseconds), or tSec (deciseconds).
When the packet marking option is used, all packet times will be displayed relative to that
marked packet. To mark a packet, use the arrow keys to move the cursor to the selected packet
number, then press "m" The time for that packet will be set to 0. All packets received before that
packet will have negative time values. All packets received after that marked packet will have
progressively higher positive time values.
Packet Number Received at Time Packet Length
0021 0000022190 mSEC 0060
Destination Address Source Address
FFFFFFFFFFFF 02608C9BED38
EtherNet Type is 0BAD, VINES IP
Check Sum Packet Length Protocol Type
D75D 0x001A 04, ARP
Transport Control Hop Count
0 0
Dest Network Dest SubNet Source Network Source SubNet
FFFFFFFF FFFF 00000000 0x0000
Packet Type Network Number Subnetwork Number
Query 126697007 0x9183
Hit Escape to EXIT Packet Details
Packet Number Received at Time Packet Length
0009 0000003190 mSEC 0028
Destination Address Source Address
001.001.001.001 001.001.001.001
45 00 1C 00 01 00 00 00 40 01 76 DD 01 01 01 01 [email protected].....
01 01 01 01 08 00 C3 ED 34 12 00 00 ........4...
Hit Escape to EXIT Packet Details
ESC - Exit Menu
‘u’ - Previous Menu
‘d’ - Next Menu
‘h’ - Top of Packet List
‘e’ - End of Packet List
Enter - Display Packet Details
‘t’ - Time Menu
‘m’ - Marks Packet as Start Time
Cursor- to select an entry
Hit any key to exit Help