Appletalk capacities, Configuring appletalk capacities, Appletalk capacities configuration elements – Enterasys Networks CSX6000 User Manual
Page 363: Appletalk capacities 363, Configure appletalk capacities
Central Site Remote Access Switch 363
C
ONFIGURING
A
PPLE
T
ALK
R
OUTING
AppleTalk Capacities
A
PPLE
T
ALK
R
OUTING
S
TATIC
R
OUTES
C
ONFIGURATION
E
LEMENTS
A
PPLE
T
ALK
N
ETWORK
T
YPE
The AppleTalk network type used by the destination network of this static route. Type can be either
Extended Network or NonExtended Network.
D
ESTINATION
N
ETWORK
R
ANGE
/N
UMBER
The remote AppleTalk network range (for Extended network) or network number (for
NonExtended network) reachable through this static route entry.
N
EXT
H
OP
D
EVICE
The AppleTalk address of the next hop device that provides access to the destination AppleTalk
network. If the next hop is over an unnumbered WAN link, then the device name is specified. The
name must be a valid Device table entry.
N
UMBER
OF
H
OPS
The number of AppleTalk routers that are traversed in order to reach the destination AppleTalk
network.
Z
ONE
N
AME
(
S
)
The name of the zone(s) on the remote AppleTalk network.
A
PPLE
T
ALK
R
OUTING
S
TATIC
R
OUTES
B
ACKGROUND
I
NFORMATION
You only need to configure static routing entries if you need to access a WAN network that is not
directly connected to the system, or if you need to access a LAN network through a router that does
not support AppleTalk RTMP. Static routes specify the AppleTalk address of the next hop router
that provides access to this network.
A
PPLE
T
ALK
C
APACITIES
C
ONFIGURING
A
PPLE
T
ALK
C
APACITIES
U
SING
CFGEDIT
1.
Select AppleTalk Capacities from the AppleTalk Routing Menu.
2.
Press 1 to set the maximum number of entries for the AppleTalk Route table.
3.
Press 2 to set the maximum number of entries for the AppleTalk zone table.
A
PPLE
T
ALK
C
APACITIES
C
ONFIGURATION
E
LEMENTS
A
PPLE
T
ALK
R
OUTING
T
ABLE
M
AXIMUM
N
UMBER
OF
E
NTRIES
Allows you to set the maximum number of defined and learned routing table entries. The default
value is 512. The maximum is 2,000.
A
PPLE
T
ALK
Z
ONE
T
ABLE
M
AXIMUM
N
UMBER
OF
E
NTRIES
Allows you to set the maximum number of defined and learned zone table entries. The default
value is 512. The maximum is 2,000.