Enterasys Networks CSX6000 - Manual (Page 593)

Central Site Remote Access Switch 593
S YSTEM C OMMANDS
Call Control Commands
To use this command for troubleshooting, you must use the System Call Trace feature to
capture any connect and disconnect messages that are generated by issuing the
call device
command. To do this:
1. Erase the current report log by entering er at the system prompt.
2. Enable the Call Trace feature by entering trace on at the system prompt.
3. Issue the call device command.
4. Display the system log messages by entering the dr command at the system prompt.
5. Check the log report for connect messages relating to the remote device you are testing.
In response to the call device command, one of the following responses
will be displayed:
Calling device
Indicates that a call request process has been initiated.
could not be found in the Device Table
Indicates that the device name could not be found in the table of configured device names.
is already connected
Indicates that a connection to a device can not be initiated if there is already a connection
to that device. The call device command cannot be used to increase bandwidth for an
existing connection.
Call attempt failed
Indicates that the request could not be executed.
More than one match for found in the Device Table
Displayed if you enter just part of a device name and that part could specify more than one
device name. You will be prompted to enter the device name again, in a more specific
manner. For example, if
call device Sch is entered, and there is a device configured
with the name Schultz, and a device configured with the name Schmidt, this message
would be displayed. You would then need to enter at least
call device Schu to
successfully initiate a call to the device Schultz.
is not callable
Each PPP device in the device database can have one or two phone numbers at which they
can be called. This message is displayed if the device has no phone number specified.
Re-enter the name, or to cancel
The device name must be re-entered.