Enterasys Networks CSX6000 - Manual (Page 489)

Central Site Remote Access Switch 489
S YSTEM M ESSAGES
System Message Summary
Bridge is operating in RESTRICTED mode
Bridge is operating in UNRESTRICTED mode
One of the above messages will be displayed to indicate the configured Bridge mode of operation.
Calculating CRC’s.....
An X-Modem transfer has been completed and the received data is being checked for integrity.
Callback type is not currently supported.
During callback negotiation between the CyberSWITCH and the remote device, an unsupported
type of callback was received.
Call control detected near end problem - Slot= Port=
The system detected a problem when initiating a call over the indicated line. The call will be retried
over a different line if possible.
Call_ID in use in HOST_CALL_REQUEST
An error has been detected in the R2 or RBS signaling procedure, which typically results in a failed
call. Contact your Distributor or Customer Support.
Calling Line ID Failure, Duplicate ID -
A call has come in for a device that is using Calling Line Id (CLID) as the only authentication
method, and the given CLID is not unique across all devices.
Calling Line ID Security Failure
The system has rejected a device due to a mismatch between the Calling Line Id presented by the
caller and the Calling Line Id in the on-node device database or obtained via an off-node
authentication server such as RADIUS.
Calling Line ID Security Failure , Device:
The system has rejected a device due to a mismatch between the Calling Line Id presented by the
caller and the Calling Line Id in the on-node device database or obtained via an off-node
authentication server such as RADIUS. The device’s name is also contained within the database.
Calling Line ID Security Failure - off-node authentication server not supported
The system authentication type is configured to obtain device information off-node, for example
from a RADIUS server; however, such transactions are not yet supported when Calling Line Id
Security is enabled.
Call Rejected, Maximum Bandwidth already in place to Device Id
An incoming call was rejected because the Maximum Data Rate parameter was exceeded for the
indicated device. The Maximum Data Rate parameter can be configured for PPP devices under the
configuration utility CFGEDIT or through the Manage Mode.
Call Rejected, No Called TN IE
The switch did not deliver an Information Element for the call. This problem normally occurs if you
are connected to a point-to-point line and have the System configured for a multipoint line. If you
are connected to a multipoint line and get this message, call your phone company and report the
problem.
Call Restrictions have been disabled by user command
The user has disabled Call Restrictions via the
callrest off Dynamic Management command.