Central Site Remote Access Switch 555
T
RACE
M
ESSAGES
X.25 Trace Messages
In - X25 CONNECTION CONFIRMATION ConnId= Access=
RemDteAddr=
The system has received a connect message from the network. This indicates that a new call is now
established.
In - X25 CONNECTION INDICATION ConnId= Access=
RemDteAddr=
The system has received an incoming call from the network. The system will respond with a
connect or a disconnect message.
In - X25 DATA LCN , bytes
Data transfer.
In - X25 DCE Clear Conf LCN , bytes
The DCE is confirming that an SVC call has been cleared by the DTE.
In - X25 DCE Interrupt LCN , bytes
An interrupt packet has been received from the DCE. Flow control procedures do not apply to
interrupt packets.
In - X25 DCE Intr Conf LCN , bytes
The DCE is confirming that an interrupt packet has been received.
In - X25 DCE REJ LCN , bytes
The DCE has detected a packet sequence error.
In - X25 DCE Restart Conf LCN , bytes
The DCE is confirming that all virtual circuits have been reset.
In - X25 DCE RNR LCN , bytes
The DCE is not ready to receive packets from the DTE.
In - X25 DCE RR LCN , bytes
The DCE is acknowledging data packets from the DTE.
In - X25 Diagnostic LCN , bytes
The DCE is providing a diagnostic packet with a cause and an error code.
In - X25 DISCONNECT CONFIRMA]TION Connid= Access=
The system has received a disconnect confirmation message from the network. This is usually
received after a call disconnect is either initiated by the system or the network.
In - X25 DISCONNECT INDICATION ConnId=< connection Id > Access=< access index > Cause=for disconnect> Diag=
The system has received a disconnect message from the network.
In - X25 Incoming LCN , bytes
An SVC call has been received from the DCE.
In - X25 Reset Ind LCN , bytes
The DCE is resetting a virtual circuit.
In - X25 Restart Ind LCN , bytes
The DCE is resetting all virtual circuits.
