Enterasys Networks CSX6000 - Manual (Page 494)

USER’S GUIDE
494 CyberSWITCH
Configured adapter # ’x’ type does not exist
The interface adapter indicated does not match the resource configuration in the system. Correct
the configuration on the system.
Connection disconnected for license violation
A connection was disconnected because there were more connections in place than allowed with
your version of the system software. A larger software version should be ordered.
Could not find peer in ip_wan_device_connected
IP reported a new IP stream to RADIUS Accounting, and RADIUS Accounting does not have any
record of this peer. Contact your distributor or Customer Support.
Could not find peer in Stop_accounting_Session
This condition occurs if RADIUS Accounting is enabled while a call is up, and then the call
disconnects. This situation is normal. However, if this occurs at any other time, a problem may
exist. Contact your distributor or Customer Support.
Could not find port for static route with next hop address
Contact your distributor or Customer Support.
Could not get Call Restriction information
Contact your Distributor or Customer Support.
Could not get current monthly charges information
Could not get the current monthly call charge information on the system. The call charge feature
will be disabled and the problem should be reported. Contact your Distributor or Customer
Support.
Could not obtain fcr packet buffer
AppleTalk related. Contact your distributor or Customer Support.
Couldn’t find speech service -
An incoming call was received which specified Speech Bearer Service capability. Speech service is
not currently supported with the System. Most likely, the incoming call was a wrong number. The
system will attempt to treat the call as 56 Kbps data.
CSM at is now being used as PRIMARY.
The device at the indicated IP addressed is now acting as a primary CSM service. The primary
service is selected through the CSM GUI. When configuring services, you first add an entry for each
service, then optionally configure managing information to designate primary and secondary
services for the network’s Access Servers.
Current monthly charges reset for new month
Reported on the first day of the month to indicate that the current monthly call charges value is
being reset to zero.
Data link down: Slot= Port= Ces
The data link on the specified line is down. If all the data links for a line are down, the line is
disabled for switched connection use.