Enterasys Networks CSX6000 - Manual (Page 393)

Central Site Remote Access Switch 393
C ONFIGURING O THER A DVANCED O PTIONS
Default Async Protocol
T ERMINAL M ODE
U SING CFGEDIT
1. From Options, select Default Async Protocol.
2. Select Action on Data Timeout.
3. Select Use Terminal Mode.
4. Next, select Data Timeout Value. Change value, in seconds, as desired (minimum: 1; maximum:
60).
5. Return to Main Menu and select Security.
6. Select Network Login Information.
7. Select Network Login General Configuration.
8. Select Terminal Server Security:
a.
To default to remote analog console access for system management, select Use
Administrative Login.
b. To default to user-level authentication before PPP transfer, select the authentication server
you plan to use. Your choices are: RADIUS, TACACS and ACE. In addition, you must also
configure the remaining security options to support user-level authentication. Refer to
Security Overview (and its related chapters) for more information.
c. If you want the default to be no terminal access when time has expired, select Do not allow
terminal access.
U SING M ANAGE M ODE
termopt
Allows you to change the default async protocol configuration as if in CFGEDIT screen.
C ALL D ISCONNECT
U SING CFGEDIT
1. From Options, select Default Async Protocol.
2. Select Action on Data Timeout.
3. Select Disconnect.
4. Next, select Data Timeout Value. Change value, in seconds, to the amount of time you want the
system to wait before disconnecting (maximum: 60 seconds).
U SING M ANAGE M ODE
termopt
Allows you to change the default async protocol configuration as if in CFGEDIT screen.
D EFAULT A SYNC P ROTOCOL C ONFIGURATION E LEMENTS
A CTION ON D ATA T IMEOUT
Determines the action the CyberSWITCH will take when it receives no data during the autosense
mode and time has expired. Configurable values are: Disconnect, Use PPP Protocol, and Use Terminal
Mode. The default is Disconnect.