Enterasys Networks CSX6000 - Manual (Page 557)

Central Site Remote Access Switch 557
T RACE M ESSAGES
X.25 (LAPB) Trace Messages
Out - X25 DTE RR LCN , bytes
The DTE is acknowledging 1 or more data packets received from the DCE.
Out - X25 Reset Ind LCN , bytes
The DCE is resetting a virtual circuit.
Out - X25 Reset Request LCN , bytes
The DTE is resetting a virtual circuit.
Out - X25 Restart Ind LCN , bytes
The DCE is resetting all virtual circuits.
Out - X25 Restart Req LCN , bytes
The DTE is resetting all virtual circuits.
X25 access in state for event
Tracks the X.25 access as it is coming up or going down, defining the state it is in and the event that
is occurring.
X.25 (LAPB) T RACE M ESSAGES
You can trace X.25 Link Access Procedure Balanced (LAPB) incoming and outgoing packets. This
LAPB trace information is placed into the Report log, which can be accessed by using the
dr
command. Enable this feature by using the trace lapb on command, and disable it with trace
lapb off .
X.25 (LAPB) T RACE M ESSAGE S UMMARY
In - LAPB DISC
The DCE link layer is going off-line.
In - LAPB DM
The DCE is going off-line.
In - LAPB FRMR
The DCE has received an invalid frame.
In - LAPB I Frame, Tx Sequence = , Rx Sequence =
The DTE has received a data frame from the DCE.
In - LAPB REJ, Rx Sequence =
The DCE has detected a sequence error in the link layer.
In - LAPB RNR, Rx Sequence =
The DCE is not ready to receive more frames.
In - LAPB RR, Rx Sequence =
The DCE is acknowledging one or more frames from the DTE.
In - LAPB SABM
The DCE is resetting the link layer.