Enterasys Networks CSX6000 - Manual (Page 511)

Central Site Remote Access Switch 511
S YSTEM M ESSAGES
System Message Summary
[IP] WAN (Direct Host) Interface for network on LAN port initialized successfully
This message is posted when WAN (Direct Host) interface for the indicated network is initialized
successfully.
[IPCP] Invalid pre-configured IP address for , ignored
There is a configured IP address for the remote device in the Device Table, but the IP address does
not belong to any configured WAN interfaces. Check the configuration. You will most likely need
to add another WAN interface.
[IPCP] IP Address Pool - Out of IP addresses
IPCP needed to allocate an IP address from the IP address pool, but there were no IP addresses
available in the IP address pool. You may need to add more IP addresses to the pool.
[IPCP] Option Negotiation Failure, Non-Convergence detected
IPCP is terminated because an agreement could not be reached on the details of protocol. Refer to
the specific documentation for the device in question to determine if it is configured correctly.
Then, contact your Distributor or Customer Support.
[IPCP] Remote device does not negotiate IP address
Please configure IP address for the device
The IP address for the remote device is either improperly configured, or not configured at all.
Check configuration and adjust.
[IPFILT] Filter “abcd” does not exist, ignored by application point “xyz”
This particular error message detects that an attempt has been made to apply a non-existent filter.
In theory, this can only happen if someone manually modifies a configuration file (other than
through CFGEDIT or Manage Mode).
[IP Host] Call Dropped: ID Response was not received from remote
The system did not receive a valid identification exchange from the remote IP Host. The system has
rejected the incoming call. Refer to the Quick Start for proper setup of your particular device.
[IP Host] Call Dropped: XID was not received from remote
The system did not receive a valid identification exchange from the remote IP Host. The system has
rejected the incoming call. Refer to the Quick Start.
[IP Host] Security Rejection - Digit string wrong length
The system did not receive a valid identification exchange from the remote IP Host. The
Identification digit string from the remote device was not of an appropriate length. This string must
be a 24 character string of ASCII digits (0-9), which is blank padded. The system has rejected the
incoming call.
[IP Host] Security Rejection - Invalid Security ID
The system has received an IP Host Id, , from a remote device that is not configured in
the Device List. The system has rejected the incoming call. Verify that the IP Host ID in the Device
List information is identical to the IP Host Id configured in the remote device.
[IP Host] Security Rejection - Security ID cannot be validated with Authentication Server
The System authentication type is configured to obtain device information off-node, for example
from a RADIUS server; however, such transactions are not yet supported when IP Host ID Security
is enabled.