Enterasys Networks CSX6000 - Manual (Page 525)

Central Site Remote Access Switch 525
S YSTEM M ESSAGES
System Message Summary
RBS: Encountered unknown source ID.
RBS_out_SM: NO Dial Digits supplied.
RBS: Received unknown primitive from CC.
RBS: Received unknown primitive from L1.
RBS: Received unknown primitive from ME.
RBS: Received unknown primitive from RBS.
The above Robbed Bit Signaling messages indicate that the system software sent a message to the
RBS state machine that the state machine was unable to recognize or the information was incorrect.
If this message is displayed in the log messages, contact your Distributor or Customer Support.
RBS: LIF_AddTimer failure.
An event occurred that the RBS task interpreted as a call signaling event, but layer 1 is not properly
initialized. Ensure that an ISDN line is not plugged into a RBS card.
RBS: LIF_GetBuffer failure.
RBS: Unable to send host CALL_CLEARED.
RBS: Unable to send host CALL_CONNECTED.
RBS: Unable to send host CALL_REQUEST_ACK.
RBS: Unable to send host HOST_CALL_INDICATION.
RBS: Unable to send host REMOTE_DISCONNECT
RBS: Unable to send package to host.
The above Robbed Bit Signaling messages indicate that the WAN card is not communicating
properly with the host, probably due to a card failure. Contact your Distributor or Customer
Support.
RBS_out_SM: Timeout waiting for WINK.
The system went off-hook and the switch never “winked” back, going off-hook for a specified
amount of time and then returning to on-hook. The switch must wink back in order to tell the
system to start dialing. Contact the telephone company and ensure that the line is configured for
wink-start.
RBS: Unexpected event chan = , state =
An illegal signaling event occurred in the RBS task on the specified channel. Ensure that the line is
configured correctly and that it is using the expected RBS protocol. Excess noise on the line may
also cause this event.
Read 0 bytes from file for WAN card in slot
If seen repeatedly, the above message indicates a problem with your hard drive. Contact your
Distributor or Customer Support.
Ready for XModem Download - to abort
The user has requested an attempt to UPDATE the system software, or it was not possible to Boot
the system the last time it was attempted.
Reattempting to Install File Set into Flash Memory
The SSB is re-attempting to install the FileSet. The Flash File System may have been corrupted when
attempting to install the FileSet the first time. In the meantime, the Flash File System has been
formatted.
Rebooting...
The system is going to wait until the WatchDog timer expires, which causes the entire system to
reboot.