Enterasys Networks CSX6000 - Manual (Page 507)

Central Site Remote Access Switch 507
S YSTEM M ESSAGES
System Message Summary
IePvcStatus: Received Status Report for unknown PVC #
The indicated unknown DLCI was indicated in a STATUS message received from the network. This
DLCI number is entered in the “unknown DLCI” list and can be displayed via the FR LMI system
console command.
Incoming call from , Slot=, Port=, Chan= Rejected by BW
Reservation
A bandwidth reservation message. Indicates that a call has come in from the indicated device, on a
line that is not in this device’s profile. The call will be disconnected. If you see this message often,
check the remote device’s configuration to prevent wasted calls.
Initial TDM Clock Master:
The external line indicated has been selected as the master clock source.
Initializing...
Displays the current state of the system (initialization).
Installing File Set into Flash Memory
The file set, received via X-Modem, has successfully passed its verification tests and is now being
written into the Flash File System.
Insufficient space for buffer pool creation
There is not enough system memory to proceed with the creation of the requested size buffer pool.
Contact your Distributor or Customer Support.
Interrupt fault on WAN Adapter in Slot
The interrupt jumper for the WAN Adapter in the specified slot is missing or misplaced.
Invalid caller number: -
The incoming call security feature is enabled and a call was received from an unknown remote site,
therefore the call was disconnected. If the call was from a valid remote site, the device list must be
updated to include the remote site's phone number.
Invalid Call_ID in HOST_CALL_CONNECTED
Invalid Call_ID in HOST_CALL_DISCONNECT
An error has been detected in the R2 or RBS signaling procedure, which typically results in a failed
call. The error was due to unrecognizable or incorrect information. If problem persists, contact your
Distributor or Customer Support.
Invalid CLLM received on Access
An invalid CLLM message was received on the indicated Frame Relay Access. The message had
either missing elements or invalid contents.
Invalid LAN Adapter identifier
The system has detected invalid LAN adapter hardware. Check for proper LAN adapter
configuration and hardware installation.
Invalid Password given
The remote Combinet sent a password that did not match any device table entries. This most likely
is due to a configuration error. Check the configuration, and change the password.