Enterasys Networks CSX6000 - Manual (Page 499)

Central Site Remote Access Switch 499
S YSTEM M ESSAGES
System Message Summary
CFGEDIT. If the board is configured properly, and the message still appears, contact your
Distributor or Customer Support.
DM card in slot will not come out of reset
There are problems initializing the board. Contact your Distributor or Customer Support.
DM upgrade timeout. Board=, Modem=
DM upgrade error during download. Modem says = xxx
DM upgrade no response at start. Board=, Modem=
DM upgrade flash erase failed. Board=, Modem=
DM upgrade no response at end. Board=, Modem=
There were problems while attempting to update the firmware of the specified modem due to
either a corrupt firmware file or hardware problems. Reseat the card in its ISA slot, and/or check
the MVIP cabling. If problems persist, contact your Distributor or Customer Support.
DM upgrade started. Board=, Modem=
The system has begun to update the firmware of the specified modem on the Digital Modem card.
Watch for subsequent log messages to ensure the update is successful.
DM session in unknown upgrade state. Board=, Modem=
There were problems while attempting to update the firmware of the specified modem due to
either a corrupt firmware file or hardware problems. Contact your Distributor or Customer
Support.
DM upgrade success. Board=, Modem=
The system has successfully updated the firmware of the specified modem on the Digital Modem
card.
DM: TimeSlot driver circuit id already in use on CREATE
DM: No TimeSlot driver circuits available for CREATE
DM: TimeSlot driver circuit id not in use on REMOVE
DM: TimeSlot driver circuit id not found on REMOVE
There were problems related to the Digital Modem’s use of the TDM bus. Contact your Distributor
or Customer Support.
Downloading Bootstrap to DM card in slot
Informational message stating that the system is attempting to initialize a Digital Modem card.
Watch for subsequent log messages to ensure the initialization is successful.
Downloading DM card in slot with operational software
Informational message displayed during a successful initialization. Watch for subsequent log
messages to ensure the initialization is successful.
Downloading WAN card in slot with operational software
Informational message during a successful system initialization. The status of the download
process for WAN card in slot is identified. This should be reported after the “Bootstrap
came alive...” message for a given adapter.
DSL test failed to establish Layer 1, port=
During power up, all WAN lines undergo a test to see if Layer 1 can be established. This message
indicates a test failure. Check the wiring. If correct, contact your phone company.