Enterasys Networks CSX6000 - Manual (Page 539)

Central Site Remote Access Switch 539
S YSTEM M ESSAGES
System Message Summary
Unable to send device information request to CSM after a terminal authentication.
Unable to send information to CSM. Verify proper configuration of CSM and Call Control options.
Unable to send DL Config Request
Unable to send DSL Config Request
Unable to send Terminate DSL Request
The above three messages indicate that an attempt has been made to dynamically update the Data
Link configuration, but the system is unable to send an update message down to a Basic Rate
adapter. Restart the system and review the configuration for the adapter. If the problem persists,
the indicated adapter card may be faulty. Contact your Distributor or Customer Support.
Unexpected error during transmission of LMI frame
A system error occurred during the actual transmit request for an LMI frame. Contact your
Distributor or Customer Support.
Unknown Calling Bridge
MAC address security is enabled and the remote Combinet does not match any of the defined
devices.
Unknown message type in SIG_get_rsc_inbound
Unknown message type in SIG_get_rsc_outbound
An error has been detected in the R2 signaling procedure, and will typically result in a failed call.
The error was due to unrecognizable or incorrect information. If problem persists, contact your
Distributor or Customer Support.
Unknown DLCI in CLLM message
The network has sent a CLLM message which has referenced the indicated DLCI that has not been
configured. Check the system configuration for the indicated DLCI.
Unknown Security Association
An incoming datagram specifies a Security Parameter Index (SPI) which has not been defined on
this node. Verify the encryption parameters on both nodes. Adjust if necessary so that both nodes
reflect the same SPI.
Unmatched Login Task
This represents an internal system error. Contact your Distributor or Customer Support.
Unsupported Combinet protocol received:
An unsupported Combinet protocol attempted to connect to the system. Contact your Distributor.
You may need to upgrade software to support this.
Unsupported Combinet protocol version received: ‘‘. [Device: ]
An unsupported Combinet version attempted to connect to the system. Contact your Distributor.
You may need to upgrade software to support this.
Updating CyberSWITCH from “”
The specified file, received during a Reliable Remote Upgrade, was successfully loaded into
memory and will now be verified before installation into the Flash File System.