Enterasys Networks CSX6000 - Manual (Page 514)

USER’S GUIDE
514 CyberSWITCH
[IPX SAP] Buffers allocated
The IPX SAP successfully allocated the buffers needed to transmit IPX SAP packets.
[IPX SAP] SAP Protocol Initialization successful
The IPX SAP protocol was successfully initialized.
[IPX SAP] Shutdown complete
The IPX SAP protocol was successfully shutdown via Dynamic Management. No IPX SAP service
information will be transmitted or received. Any services learned via IPX SAP will soon expire.
[IPX SAP] Space available in service table
A service entry has become available in the full service table.
[IPX SAP] Unable to add service, service table full
The service table has become full. The maximum number of service entries should be increased.
Note:
This message will not recur in the log until space becomes available in the service table.
[IPXCP] Add Network Address to Pool with value above
This message informs the administrator that negotiation was not possible since non-convergence
was detected the network address sent by the peer was not acceptable by us and we do not have
any network address to assign to the peer. The possible remedy is to configure more IPX addresses
with a value more than in the Address Pool.
[IPXCP] IPX Address Match.
[IPXCP] Device address same as another device address
The remote device indicated by requested to use an already existing IPX network number
and node number.
[IPXCP] Our Node Address is
This message informs the administrator that the peer has assigned us a node number because the
system did not have a node address and the peer needs a node address. This node address will be
used by the peer to identify this system.
[IPXWAN] Master Slave Conflict. Change Internal Network Number above
This message indicates that over the IPXWAN link, the master and slave roles could not be
determined. The internal network number of the system must be changed to ensure proper
IPXWAN negotiation to occur.
[IPXWAN] IPX Internal Network Number must be configured.
You must configure a valid internal network number in order for IPX routing to work properly.
L3_CallRefSelect Call Reference wrapped
Status message indicating that Layer 3’s call reference value has wrapped. If this message is posted
frequently, report the problem.
LAN Adapter Abort
The Ethernet adapter or subsystem is being interrupted as part of the error recovery process. If the
system fails to operate normally, or the warning continues to occur, then report the event using the
problem reporting form included in Getting Assistance.