Enterasys Networks CSX6000 - Manual (Page 457)

V
ERIFYING
S
YSTEM
O
PTIONS
O VERVIEW
This chapter describes the verification process for various system options. It includes the
verification process for:
• SNMP
• Dial Out
• Call Detail Recording
• Compression
• Reserved Bandwidth
• DHCP Relay Agent and Proxy Client
• Semipermanent connections
• D Channel Callback
• Modem Callback
• Proxy ARP
To perform the verification procedures, WAN lines must be available and ready to use. LAN
attachment components must also be available and ready to use.
During some of the procedures, we ask you to enter an administration console command. To enter
these commands, you must have an active administration session. If you need instructions for
starting an administration session, refer to
Accessing the CyberSWITCH .
Note: At least one remote device is required to proceed with many of the verification procedures.
SNMP
1. To verify that the SNMP feature is operational, enter the snmp stats command at the
administration console. If the statistics display appears, the SNMP subsystem should be fully
operational.
2. If the following message is displayed, SNMP is not operational:
SNMP is not enabled
Try the following:
Check the configuration of the CyberSWITCH. In order for the SNMP Agent to become
enabled, both the IP option and the SNMP Agent must be enabled in the CyberSWITCH
configuration. (You may check the configuration by using the
options and snmp commands
in Manage Mode; however, you can only make changes to these items by using CFGEDIT).
3. Enter the dr command at the administrative console. If the following message appears, the IP
subsystem has initialized successfully:
[IP] IP router is initialized successfully