Enterasys Networks CSX6000 - Manual (Page 314)

USER’S GUIDE
314 CyberSWITCH
Notes: The DHCP Server must have a route specified to get back to the DHCP-enabled router
Alex, or use Alex as its default gateway.
When you are using a RLAN Interface, you are limited to one subnetwork.
Configuration for IP Router "Alex" Configuration for Remote Bridge "Ruby"
System Information:
System Name = Alex
System Password = stone System Information:
System Name = Ruby
System Password = rubble
Security Level = Device Level (On-node
Device Database, PAP security) Security Level = Device Level (On-node
Device Database, PAP security)
Bridging disabled Bridging enabled
Bridge Packet Data Filter: offset=1;
mask=00;value=00;action=CONNECT;
dist list=“Alex”
IP enabled (router mode)
I/F = LAN (192.168.1.168)
I/F = WAN RLAN
(204.157.42.190) IP disabled
DHCP enabled
Relay Destination # 1 = 192.168.1.5
(interface = “N/A”)
Hop Count Threshold = 4 DHCP disabled
Device = “Ruby”
ISDN Line Protocol = PPP
Dial Out Phone # = 5311
PAP Password = “rubble”
IP Address = 204.157.42.0
IP Routing = disabled
Bridging = enabled
Make calls for Bridge data = disabled Device = “Alex”
ISDN Line Protocol = PPP
Dial Out Phone # = 5411
PAP Password = “stone”
IP Address = (none)
IP Routing = disabled
Bridging = enabled
Make calls for Bridge data = enabled